your hotspot is created you can see it in your other devices. Press Enter > now you will see the command prompt.Step 2: This is to switch on the created WiFi network Again Enter the below command. Here "MyWiFi" is your username and "Mypassword" is your password.Hit Enter and now your hotspot is activated in your PC/Laptop.Netsh wlan set hostednetwork mode=allow ssid=MyWiFi key=Mypassword Enter the below command (your CMD must be open in administrativemode). Hey guys Hope you are doing well.So this video is Based on How to Hack Wifi password Using CMD or Command Prompt.Commands: 1.netsh wlan show sh w.Step 1 : To Create WiFi Hotspot Network in Windows Laptops To save it type : netsh wlan export profile name = kinibigdeal( not by name but change it to the name of the detected wifi) Name= (put the name of wifi your system detect) To connect to the wifi network, type the following Mode = bssid(it will show all the available wifi network, take note of the names) Inside the command prompt, type the following Here’s how you can find the Wi-Fi password through LAN using the Windows command line. Go to command prompt, click start up menu on your system, click RUN, type Cmd, and click ok to open the command prompt Sometimes you might be frustrated especially when your system detect a wifi network but you are restricted from accessing it due to users password, now i can teach you a simple trick to hack the password.
0 Comments
Leave a Reply. |